Questions & discussions of garage door operator problems and solutions.

Latest topics

» Seal your garage door
Today at 3:00 am by brooklynnygarage

» Pole Barn Door Opener
Sat Aug 19, 2017 12:13 pm by OldBlue

» need to get garage door open
Sat Aug 19, 2017 7:11 am by benchbella

» advise on garage repair in phoenix az
Fri Aug 18, 2017 11:02 am by sandykiwi66

» Garage door not opening.
Fri Aug 18, 2017 11:00 am by sandykiwi66

» What is the best garage door for all homes?
Fri Aug 18, 2017 10:57 am by sandykiwi66

» Welcome To The Forums
Mon Aug 14, 2017 6:55 am by queensgarage

» What goes into the cost of a commercial garage door?
Mon Aug 14, 2017 6:50 am by queensgarage

» What type of spring is better...extension or torsion?
Mon Aug 14, 2017 5:04 am by njoverheadgaragedoors

Buy Marantec Remotes

Buy Raynor Remotes

Buy Raynor Remotes


    raynor pilot adjustment



    Posts : 2
    Join date : 2011-02-01

    raynor pilot adjustment

    Post  web on Tue Feb 01, 2011 8:08 pm

    raynor pilot - two garage doors in building ate the gears - installed a new set of gears, door went down perfectly, started up and stopped approx. 6" up. if i got it up, it would then only come down approx. 6" and stop. local installer said to try an rpm board. installed an rpm/interupter, door now closes, then starts to open approx. 6" and stops. if i get it up, it will then go down approx. 6" and stop. unlatch the door and it makes a normal run. is it now completley in the adjustment of pressure switches and top bottom limits?

    Posts : 208
    Join date : 2009-04-28

    Re: raynor pilot adjustment

    Post  GDZone on Fri Feb 04, 2011 1:27 am

    You could try adjusting the sensitivity. If that doesn't work then I would try replacing the limit assembly.


    Posts : 2
    Join date : 2011-02-01

    raynor pilot

    Post  web on Fri Feb 04, 2011 11:47 am

    thanks for the reply. i already got it and your right, it was the sensitivity. thanks

    Sponsored content

    Re: raynor pilot adjustment

    Post  Sponsored content

      Current date/time is Mon Aug 21, 2017 3:32 am