I am a sparky by trade but I have an issue with my dads garage door.
Ok so it opens a to about quarter of the way up then stops. If u press open again it goes up a few turns and then comes back down to the position it stopped at the first time. If u wind it up manually it comes down on the motor fine.
There is no beam but there is a pressure strip on the bottom. There are also a grey long panel that is screwed to the door with 3round batteries in which I have replaced and a grey square on the frame that lines up with this. I'm not to sure what this bit is? Could it be to link it to the alarm system maybe??
I can only think to replace the control panel but I'm not 100% this will solve the issue and I don't want to spend money if it's not required. It's an older door sws I think it has a light on the panel which flashes green Amber and red. The sequence of colours is a trouble shooter in the manual but if otter says different things ie different sequence of lights flashing?
Any help and advice would be great!!
Today at 7:30 am by Koby_BEZ
» Install Overhead Door Company garage door
Today at 7:13 am by Koby_BEZ
» Sell My House Fast Phoenix
Yesterday at 4:59 am by jonemartin
» MOTTIFY EU
Wed Apr 24, 2024 4:58 am by mottify
» Where is best place to buy torsion shafts locally?
Tue Apr 23, 2024 11:25 am by Rob Ryan
» Sears Door Sensors Won't Align
Tue Apr 23, 2024 5:19 am by cr-garagedoor
» Garage door spring repair
Fri Apr 19, 2024 7:38 am by garage door
» Where is the microphone in iPhone 11?
Fri Apr 19, 2024 6:52 am by techzeel
» How to Side Swipe On Instagram?
Wed Apr 17, 2024 5:55 am by Allinsider