New here and looked through forum and didn't see an answer to my question and wasn't sure where to post this, so appreciate any suggestions.
I have a overhead door company model 696CD that when I push the wall button or the remote the only thing that happens is that the light comes on and I can hear a click. prior to this it was acting up and when I would try to close it it would come down maybe 12 inches and then reverse. it would do this 2 or 3 times and then it would go down all the way. Not sure where to start looking at circuit board or something else. all wires are tight and safety sensors are operational....thanks for any suggestions
I have a overhead door company model 696CD that when I push the wall button or the remote the only thing that happens is that the light comes on and I can hear a click. prior to this it was acting up and when I would try to close it it would come down maybe 12 inches and then reverse. it would do this 2 or 3 times and then it would go down all the way. Not sure where to start looking at circuit board or something else. all wires are tight and safety sensors are operational....thanks for any suggestions
Yesterday at 10:45 am by dct@cox.net
» Craftsman Opener having issues
Yesterday at 7:30 am by Koby_BEZ
» Sell My House Fast Phoenix
Thu Apr 25, 2024 4:59 am by jonemartin
» MOTTIFY EU
Wed Apr 24, 2024 4:58 am by mottify
» Where is best place to buy torsion shafts locally?
Tue Apr 23, 2024 11:25 am by Rob Ryan
» Sears Door Sensors Won't Align
Tue Apr 23, 2024 5:19 am by cr-garagedoor
» Garage door spring repair
Fri Apr 19, 2024 7:38 am by garage door
» Where is the microphone in iPhone 11?
Fri Apr 19, 2024 6:52 am by techzeel
» How to Side Swipe On Instagram?
Wed Apr 17, 2024 5:55 am by Allinsider