My garage door motor will not stop running when the door closes. The limit switches all check out. What next?
Garage Door Zone
Questions & discussions of garage door operator problems and solutions.
2 posters
Raynor Trouble Shooting
GDZone- Admin
- Posts : 340
Join date : 2009-04-28
What model of opener do you have?
Abner- Posts : 3
Join date : 2009-12-18
I have a Model 130-7 built 9/90
GDZone- Admin
- Posts : 340
Join date : 2009-04-28
Did you take the cover off & watch the limit nuts as they travel to the limit switches? Is the close limit nut going past the limit switch & not making contact? Try pulling he spring loaded retaining rod out from the limit nut & move the nut up on the threaded rod. One revolution of the nut is about 3" of door travel.
Abner- Posts : 3
Join date : 2009-12-18
I have checked the function of the limit switches, both in service and out of service. Also the obstruction disconnect switches. The motor does not respond to any of these switches.
GDZone- Admin
- Posts : 340
Join date : 2009-04-28
If the switches are functioning properly and the limit nuts are working as they should then I would guess that there is something wrong with the logic board.
» Cenforce 25 mg: A Gentle Start to Enhanced Men’s Wellness
» Room GPT: Your AI Companion for Seamless Interior Design
» Sensing that your Internet
» I found out by myself why my garage door opening unevenly
» Ufabet เว็บแม่ API แท้จากบริษัทแม่ 100% มาตรฐานสากล
» Jobs in Dubai: Opportunities, Requirements, and Tips for Success
» How much mebendazole should I take for worms?
» Jobs in Dubai: Opportunities Await in the City of Dreams