Hi. I foolishly disconnected some of the wiring on my garage door opener (Raynor 170-7 model) due to some issues I was having with the safety sensors. I cannot remember the exact way that it was wired before. The sensor wire on one side has three separate wires (red, black, white), while the other side just has two (black, red). There are six screws on the opener to attach the wires, the descriptions are from left to right: Safety Input, Safety Power, Courtesy Light, Radio Power, Push Button, and 24 Volts. I currently have the white wire and the two black wires hooked to the 24 Volts screw, I have one red wire hooked to Safety Power, and the other to Radio Power. The safety sensors appear to be receiving power, as one green light is visiable on each of them. However, when I try to close the garage door, it goes down about two feet and then retracts (even though no obstructions). I have to hold the button down the entire time it is closing for it to work completely. Assuming I made a mistake when re-wiring the sensors. Any help would be greatly appreciated. Thanks!
Yesterday at 10:45 am by dct@cox.net
» Craftsman Opener having issues
Yesterday at 7:30 am by Koby_BEZ
» Sell My House Fast Phoenix
Thu Apr 25, 2024 4:59 am by jonemartin
» MOTTIFY EU
Wed Apr 24, 2024 4:58 am by mottify
» Where is best place to buy torsion shafts locally?
Tue Apr 23, 2024 11:25 am by Rob Ryan
» Sears Door Sensors Won't Align
Tue Apr 23, 2024 5:19 am by cr-garagedoor
» Garage door spring repair
Fri Apr 19, 2024 7:38 am by garage door
» Where is the microphone in iPhone 11?
Fri Apr 19, 2024 6:52 am by techzeel
» How to Side Swipe On Instagram?
Wed Apr 17, 2024 5:55 am by Allinsider