Garage Door Zone

Would you like to react to this message? Create an account in a few clicks or log in to continue.
Garage Door Zone

Questions & discussions of garage door operator problems and solutions.

Latest topics

» Navigating the Academic Terrain: Evaluating Writing Service Reviews
wall - LED flashing on wall control, not in lock mode EmptyToday at 7:49 am by Edna Fosse

» Exploring Reviews of Legal and Trusted Online Casinos with OnlineCasinosSouthAfrica
wall - LED flashing on wall control, not in lock mode EmptyToday at 6:42 am by Willie Chapman

» Garage door opens then door goes back a few inches then opens again...
wall - LED flashing on wall control, not in lock mode EmptyToday at 4:29 am by shunchi320

» Door closing with loud noise, any suggestions
wall - LED flashing on wall control, not in lock mode EmptyToday at 4:28 am by shunchi320

» Garage door not opening
wall - LED flashing on wall control, not in lock mode EmptyToday at 4:26 am by shunchi320

» Commercial Garage Door Installation
wall - LED flashing on wall control, not in lock mode EmptyToday at 4:21 am by shunchi320

» Garage Door Repair
wall - LED flashing on wall control, not in lock mode EmptyToday at 4:18 am by shunchi320

» Garage door still can open and close in a power outage
wall - LED flashing on wall control, not in lock mode EmptyToday at 4:16 am by shunchi320

» Tips For Installation Of Garage Door
wall - LED flashing on wall control, not in lock mode EmptyToday at 4:11 am by shunchi320

Keywords

remote  problems  raynor  Overhead  craftsman  opener  sensors  extension  linear  marantec  liftmaster  garage  sensor  Genie  wall  light  Chamberlain  shaft  spring  button  wont  model  close  doors  Seal  open  

Counter


2 posters

    LED flashing on wall control, not in lock mode

    jools
    avatar
    jools


    Posts : 2
    Join date : 2020-01-18
    • Post n°1

    wall - LED flashing on wall control, not in lock mode Empty LED flashing on wall control, not in lock mode

    Post  jools Sat Jan 18, 2020 11:22 pm

    Hello. I have a Chamberlain LW600WFCi 3/4 hp garage door opener, which up until recently, worked great. What has happened is that all of a sudden the LED on the indoor wall control has started flashing, and it will no longer open the door. In fact, it won't turn on the light either. The outdoor keypad and vehicle remotes all still work fine, and the safety beam/sensors are working fine also. I've tried to hold lock button for 2 (or more) seconds, but no result. Another thing, is that the ADJUSTMENT button (rectangular button in between the up and down arrows, under the light shield on the motor unit) is perpetually flashing. I'm not sure if it was doing that before or not. Just before I go out and buy a new wall control I wanted to make sure there wasn't something I was missing. Any ideas? Thanks.
    • Back to top
    jools
    avatar
    jools


    Posts : 2
    Join date : 2020-01-18
    • Post n°2

    wall - LED flashing on wall control, not in lock mode Empty Re: LED flashing on wall control, not in lock mode

    Post  jools Wed Feb 19, 2020 12:00 am

    Bump
    • Back to top
    Mkhoury
    avatar
    Mkhoury


    Posts : 1
    Join date : 2024-05-06
    • Post n°3

    wall - LED flashing on wall control, not in lock mode Empty Re: LED flashing on wall control, not in lock mode

    Post  Mkhoury Mon May 06, 2024 9:01 am

    Did you get help with this issue? I’m having the same problem and don’t see a reply.
    • Back to top
    Sponsored content

    Sponsored content


    • Post n°4

    wall - LED flashing on wall control, not in lock mode Empty Re: LED flashing on wall control, not in lock mode

    Post  Sponsored content

    • Back to top
      Current date/time is Sat May 11, 2024 10:14 am