So I’ve installed the garage door opener and everything but was confused about the wires(pre installed wires) that go to one of the sensors and the actual opener. It’s just a big loop back into the ceiling and wall. I talked to my construction guy who supervised on the house asked his electrical guy and said to cut them and feed one part for the sensor and one for the opener button next to the switch. Just wondering if anyone can help and confirm this. Pictures if it helps.
Today at 7:49 am by Edna Fosse
» Exploring Reviews of Legal and Trusted Online Casinos with OnlineCasinosSouthAfrica
Today at 6:42 am by Willie Chapman
» Garage door opens then door goes back a few inches then opens again...
Today at 4:29 am by shunchi320
» Door closing with loud noise, any suggestions
Today at 4:28 am by shunchi320
» Garage door not opening
Today at 4:26 am by shunchi320
» Commercial Garage Door Installation
Today at 4:21 am by shunchi320
» Garage Door Repair
Today at 4:18 am by shunchi320
» Garage door still can open and close in a power outage
Today at 4:16 am by shunchi320
» Tips For Installation Of Garage Door
Today at 4:11 am by shunchi320