I have two garage doors that had a lightning power surge. I replaced the logic board and safety sensors on both. It fixed one, but the other still does not work. I have swapped boards and it is not a faulty circuit board. When I try to set the travel limits, the motor only works for about one second when I try to program the up travel. It then makes me try to program the down travel. Again, the motor stops after about one second. If I pulse the travel buttons for less than a second, I can push it repeatedly, but if I hold it down, it trips. Any ideas about what is causing this and what is the next part to check?
Thank you!
Thank you!
Fri May 17, 2024 7:47 am by jonemartin
» What did I do wrong here... garage door opener install Pics and vid included.
Fri May 17, 2024 6:05 am by cochranejuniper
» Overhead Garage door issue
Fri May 17, 2024 5:58 am by cochranejuniper
» Latest technologies to open garage doors
Fri May 17, 2024 4:46 am by remsibradpitt5
» What safety features are important in a garage door opener?
Fri May 17, 2024 4:45 am by remsibradpitt5
» How to choose best garage door and what points should be in mind?
Fri May 17, 2024 4:44 am by remsibradpitt5
» Better Place Garage Doors
Fri May 17, 2024 4:43 am by remsibradpitt5
» Garage Door Color Selection Guide
Fri May 17, 2024 4:40 am by remsibradpitt5
» garage door siding clips
Fri May 17, 2024 4:28 am by remsibradpitt5