Garage Door Zone

Would you like to react to this message? Create an account in a few clicks or log in to continue.
Garage Door Zone

Questions & discussions of garage door operator problems and solutions.

Latest topics

» Install Overhead Door Company garage door
Question about garage door rollers EmptyYesterday at 10:45 am by dct@cox.net

» Craftsman Opener having issues
Question about garage door rollers EmptyYesterday at 7:30 am by Koby_BEZ

» Sell My House Fast Phoenix
Question about garage door rollers EmptyThu Apr 25, 2024 4:59 am by jonemartin

» MOTTIFY EU
Question about garage door rollers EmptyWed Apr 24, 2024 4:58 am by mottify

» Where is best place to buy torsion shafts locally?
Question about garage door rollers EmptyTue Apr 23, 2024 11:25 am by Rob Ryan

» Sears Door Sensors Won't Align
Question about garage door rollers EmptyTue Apr 23, 2024 5:19 am by cr-garagedoor

» Garage door spring repair
Question about garage door rollers EmptyFri Apr 19, 2024 7:38 am by garage door

» Where is the microphone in iPhone 11?
Question about garage door rollers EmptyFri Apr 19, 2024 6:52 am by techzeel

» How to Side Swipe On Instagram?
Question about garage door rollers EmptyWed Apr 17, 2024 5:55 am by Allinsider

Keywords

opener  extension  spring  button  remote  linear  Overhead  close  open  problems  Seal  model  Chamberlain  wont  marantec  doors  garage  wall  Genie  craftsman  shaft  raynor  light  liftmaster  sensors  sensor  

Counter


    Question about garage door rollers

    atrevino79
    avatar
    atrevino79


    Posts : 1
    Join date : 2020-03-24
    • Post n°1

    Question about garage door rollers Empty Question about garage door rollers

    Post  atrevino79 Tue Mar 24, 2020 2:07 pm

    Hi! I'm wanting to replace the garage door rollers because it is making too much noise while opening or closing. My question is that upon inspecting the current rollers I notice the top and bottom are 7" and the rollers in the middle are 4". Should I replace all of them for 7", 4" or keep the same mixture of rollers? Thanks for the feedback!
    • Back to top
      Current date/time is Sat Apr 27, 2024 6:45 pm