Garage Door Zone

Would you like to react to this message? Create an account in a few clicks or log in to continue.
Garage Door Zone

Questions & discussions of garage door operator problems and solutions.

Latest topics

» LED flashing on wall control, not in lock mode
marantec - Re-programing Marantec transmitter EmptyToday at 9:01 am by Mkhoury

» How to edit your birthday on Facebook?
marantec - Re-programing Marantec transmitter EmptyThu May 02, 2024 6:05 am by Allinsider

» Clinical Trials Poland
marantec - Re-programing Marantec transmitter EmptyTue Apr 30, 2024 9:25 am by Altrio

» Is Impotence a Sign of an Underlying Health Condition?
marantec - Re-programing Marantec transmitter EmptyTue Apr 30, 2024 3:12 am by ameliajames

» Old Genie BlueMax resistance adjustment sensor
marantec - Re-programing Marantec transmitter EmptyMon Apr 29, 2024 9:19 pm by Bob52

» QR code menu
marantec - Re-programing Marantec transmitter EmptyMon Apr 29, 2024 1:34 pm by lefeni

» KDE's great video edito
marantec - Re-programing Marantec transmitter EmptyMon Apr 29, 2024 1:32 pm by lefeni

» Where is the microphone in iPhone 11?
marantec - Re-programing Marantec transmitter EmptyMon Apr 29, 2024 1:29 pm by lefeni

» How to Open Garage Door Manually from Inside and Outside
marantec - Re-programing Marantec transmitter EmptyMon Apr 29, 2024 5:45 am by melanie

Keywords

remote  sensors  craftsman  Chamberlain  spring  Genie  close  liftmaster  shaft  problems  model  wont  opener  extension  garage  wall  doors  linear  Overhead  light  sensor  open  Seal  raynor  marantec  button  

Counter


2 posters

    Re-programing Marantec transmitter

    AaronLSP
    avatar
    AaronLSP


    Posts : 1
    Join date : 2011-04-17
    • Post n°1

    marantec - Re-programing Marantec transmitter Empty Re-programing Marantec transmitter

    Post  AaronLSP Sun Apr 17, 2011 7:44 pm

    My M3-2312 Marantec Mini 2-Button Remote 315Mhz was stolen from my vehicle last night. I need to change the code. All information i am finding refers to a programming connector, however the previous owner didn't leave that piece. How do I reprogram the code from the transmitter to the remaining remote?
    My Model is a 4500..
    Thank you in advance.
    Aaron
    • Back to top
    GDZone
    GDZone
    GDZone
    Admin


    Posts : 340
    Join date : 2009-04-28
    • Post n°2

    marantec - Re-programing Marantec transmitter Empty Re: Re-programing Marantec transmitter

    Post  GDZone Thu Apr 21, 2011 10:10 am

    So you have two remotes and you want to transfer the code from one remote to the other? If that's the case then you will need a programming jumper. You can find them here. If you have two M3-2312 Remotes then you'll need the "New Programming Connector".
    • Back to top
      Current date/time is Mon May 06, 2024 6:41 pm