Garage Door Zone

Would you like to react to this message? Create an account in a few clicks or log in to continue.
Garage Door Zone

Questions & discussions of garage door operator problems and solutions.

Latest topics

» Any 2 button WIRED wall mounted door opener consoles out there?
Setting limits for open and closed EmptyToday at 6:13 pm by rukiddin38@yahoo.com

» Looking for Garage Door Repair Services in Seattle
Setting limits for open and closed EmptyToday at 4:32 pm by ben_Jackob_garage

» Garage door opens then door goes back a few inches then opens again...
Setting limits for open and closed EmptyToday at 8:29 am by GrittGordon11

» installed a right hand spring for door. what drums to use
Setting limits for open and closed EmptyToday at 4:09 am by shunchi320

» Repair My Garage Door Aurora
Setting limits for open and closed EmptyToday at 4:09 am by shunchi320

» Linear garage door opener lubrication
Setting limits for open and closed EmptyToday at 4:08 am by shunchi320

» Can you flip a wood garage door to extend its life?
Setting limits for open and closed EmptyToday at 4:07 am by shunchi320

» Door goes up about a foot, stops
Setting limits for open and closed EmptyToday at 3:44 am by shunchi320

» Any garage door openers still made with doorbell-style buttons
Setting limits for open and closed EmptyToday at 3:43 am by shunchi320

Keywords

spring  extension  sensors  linear  marantec  model  button  Overhead  shaft  liftmaster  sensor  opener  garage  wont  open  raynor  craftsman  wall  Genie  close  Chamberlain  switch  Seal  problems  light  remote  

Counter


    Setting limits for open and closed

    Bigmiketx
    avatar
    Bigmiketx


    Posts : 1
    Join date : 2019-01-08
    • Post n°1

    Setting limits for open and closed Empty Setting limits for open and closed

    Post  Bigmiketx Tue Jan 08, 2019 6:16 am

    Trying to set open and closed on an older model craftsman garage door opener it will only open actually seems to be going to far but won't go back down.This is an ex wife's to do list which by time I was asked to loom at it few hands had already touched it so have no idea what has been done.
    • Back to top
      Current date/time is Tue May 14, 2024 8:20 pm