Garage Door Zone

Would you like to react to this message? Create an account in a few clicks or log in to continue.
Garage Door Zone

Questions & discussions of garage door operator problems and solutions.

Latest topics

» Navigating the Academic Terrain: Evaluating Writing Service Reviews
Safety beam EmptyToday at 7:49 am by Edna Fosse

» Exploring Reviews of Legal and Trusted Online Casinos with OnlineCasinosSouthAfrica
Safety beam EmptyToday at 6:42 am by Willie Chapman

» Garage door opens then door goes back a few inches then opens again...
Safety beam EmptyToday at 4:29 am by shunchi320

» Door closing with loud noise, any suggestions
Safety beam EmptyToday at 4:28 am by shunchi320

» Garage door not opening
Safety beam EmptyToday at 4:26 am by shunchi320

» Commercial Garage Door Installation
Safety beam EmptyToday at 4:21 am by shunchi320

» Garage Door Repair
Safety beam EmptyToday at 4:18 am by shunchi320

» Garage door still can open and close in a power outage
Safety beam EmptyToday at 4:16 am by shunchi320

» Tips For Installation Of Garage Door
Safety beam EmptyToday at 4:11 am by shunchi320

Keywords

opener  open  extension  problems  remote  Genie  Seal  wont  light  Overhead  raynor  button  marantec  liftmaster  doors  Chamberlain  sensors  garage  close  model  sensor  wall  linear  shaft  spring  craftsman  

Counter


2 posters

    Safety beam

    Gelsie
    avatar
    Gelsie


    Posts : 1
    Join date : 2020-08-09
    • Post n°1

    Safety beam Empty Safety beam

    Post  Gelsie Sun Aug 09, 2020 5:38 am

    I replaced the gears in my Overhead Door Legacy opener. Now it goes up fine but the safety beam system blinks 4 red and will not go down. What did I mess up?


    • Back to top
    find me
    find me
    find me


    Posts : 19
    Join date : 2018-02-01
    • Post n°2

    Safety beam Empty Re: Safety beam

    Post  find me Sat Oct 17, 2020 5:24 am

    Take a picture of the powerhead so I know which model opener it is. If this link is relevant, input your motor a minute or two, plug it back in. Then reprogram the open/close limits, followed by setting the force limits.

    https://geniecompany.com/data/products/programming-quick-reference.pdf
    • Back to top
      Current date/time is Sat May 11, 2024 10:06 pm