1/3 HP Craftsman opener...when using wall button, remote, or outside mounted keypad it blinks several times (maybe 10?) and goes up/down just an inch and lights flash and it stops there. Every time. To get it to open/close I have to hold button the entire time until it completes the open/close. If I hold and release half way through it reverses.
Track, door, seal all fine. Sensor lights are correct and steady on...sensors cleaned and aligned...nothing in the way of sensors or doord itself.
Not sure what parts need replaced ..maybe logic board? Any Input
Track, door, seal all fine. Sensor lights are correct and steady on...sensors cleaned and aligned...nothing in the way of sensors or doord itself.
Not sure what parts need replaced ..maybe logic board? Any Input
» Garage door opens then door goes back a few inches then opens again...
» installed a right hand spring for door. what drums to use
» Repair My Garage Door Aurora
» Linear garage door opener lubrication
» Can you flip a wood garage door to extend its life?
» Door goes up about a foot, stops
» Any garage door openers still made with doorbell-style buttons
» Continually reversing door travel