Questions & discussions of garage door operator problems and solutions.

Latest topics

» Lift Master 8065 Travel Programming Issue
Wed Jun 13, 2018 12:38 pm by ricks

» Is this garage door installed correctly?
Wed Jun 13, 2018 11:41 am by ricks

» Wired Door openers
Wed Jun 13, 2018 10:41 am by ricks

» garage door cables keep coming off drums
Wed Jun 13, 2018 10:37 am by Garages

» Shortening door.....shorten springs?
Mon Jun 11, 2018 10:54 pm by Elkjunkie

» Balancing Torsion Springs
Fri Jun 08, 2018 7:43 am by JosephClements

» Craftsman Garage Door Opener Problem
Mon Jun 04, 2018 8:42 pm by bilvihur

» Garage Door
Thu May 10, 2018 2:23 am by BillyJones

» Garage Door Maintenance
Wed May 09, 2018 7:06 am by johnpeckham

Buy Marantec Remotes

Buy Raynor Remotes

Buy Raynor Remotes

Counter


    raynor model 130-7

    Share

    boo5156

    Posts : 1
    Join date : 2011-04-17

    raynor model 130-7

    Post  boo5156 on Sun Apr 17, 2011 2:00 pm

    \

    this door closes about halfway and stops, does not reverse ..... chain had come off and put it back on and adjusted the tension.. down travel screw is adjusted all the way.....anybody got any good advice ???
    avatar
    GDZone
    Admin

    Posts : 244
    Join date : 2009-04-28

    Re: raynor model 130-7

    Post  GDZone on Thu Apr 21, 2011 10:05 am

    Since the chain was off it seems the travel limits are out of adjustment.

    You'll need to remove the cover to adjust them. After you remove the cover you'll see two white limit nuts on a threaded shaft. The one on top is the open travel limit nut and the one on the bottom is the close travel limit nut.

    To adjust the close travel: pull the retaining rod away from the limit nut. Move the nut upward on the threaded shaft for more door travel. One revolution of the nut is approx. 3" of door travel. Give it a couple of revolutions and test it. Once you get the travel to where you want it make sure the retaining rod is engaged in the slots of both nuts.

    Hope this helps.

      Current date/time is Mon Jun 18, 2018 12:51 am