Garage Door Zone

Would you like to react to this message? Create an account in a few clicks or log in to continue.
Garage Door Zone

Questions & discussions of garage door operator problems and solutions.

Latest topics

» Now Concrete Floor Poured - Now a gap at the door
door - Question about garage door rollers EmptyYesterday at 7:47 am by jonemartin

» What did I do wrong here... garage door opener install Pics and vid included.
door - Question about garage door rollers EmptyYesterday at 6:05 am by cochranejuniper

» Overhead Garage door issue
door - Question about garage door rollers EmptyYesterday at 5:58 am by cochranejuniper

» Latest technologies to open garage doors
door - Question about garage door rollers EmptyYesterday at 4:46 am by remsibradpitt5

» What safety features are important in a garage door opener?
door - Question about garage door rollers EmptyYesterday at 4:45 am by remsibradpitt5

» How to choose best garage door and what points should be in mind?
door - Question about garage door rollers EmptyYesterday at 4:44 am by remsibradpitt5

» Better Place Garage Doors
door - Question about garage door rollers EmptyYesterday at 4:43 am by remsibradpitt5

» Garage Door Color Selection Guide
door - Question about garage door rollers EmptyYesterday at 4:40 am by remsibradpitt5

» garage door siding clips
door - Question about garage door rollers EmptyYesterday at 4:28 am by remsibradpitt5

Keywords

wall  Chamberlain  Seal  Genie  close  garage  extension  model  opener  liftmaster  marantec  linear  Overhead  spring  craftsman  sensors  shaft  raynor  switch  open  wont  button  light  sensor  remote  problems  

Counter


    Question about garage door rollers

    atrevino79
    avatar
    atrevino79


    Posts : 1
    Join date : 2020-03-24
    • Post n°1

    door - Question about garage door rollers Empty Question about garage door rollers

    Post  atrevino79 Tue Mar 24, 2020 2:07 pm

    Hi! I'm wanting to replace the garage door rollers because it is making too much noise while opening or closing. My question is that upon inspecting the current rollers I notice the top and bottom are 7" and the rollers in the middle are 4". Should I replace all of them for 7", 4" or keep the same mixture of rollers? Thanks for the feedback!
    • Back to top
      Current date/time is Sat May 18, 2024 9:19 pm