bjhanson3 Fri Jan 04, 2013 1:13 pm
I too have an older Genie model G5050 that does not have down force adjustments just the old clutch style. The door opens fine stops when it hits the open switch mounted on the screw drive, but will not reverse the motor and close. There are safety beams, but those are aligned and seem to be working fine. The close switch wiring looks fine too. I am baffled, but don't want to call a repair man for a door opener worth less than the service call will cost me. Thoughts? Can I bypass the safety beam some how to check that it's working? The open and stop switch's are simple single wire grounds, so not much to check there, but maybe there is a way to test that they ground correctly? By the way I have two of these that are doing exactly the same thing.
Sat May 11, 2024 7:49 am by Edna Fosse
» Exploring Reviews of Legal and Trusted Online Casinos with OnlineCasinosSouthAfrica
Sat May 11, 2024 6:42 am by Willie Chapman
» Garage door opens then door goes back a few inches then opens again...
Sat May 11, 2024 4:29 am by shunchi320
» Door closing with loud noise, any suggestions
Sat May 11, 2024 4:28 am by shunchi320
» Garage door not opening
Sat May 11, 2024 4:26 am by shunchi320
» Commercial Garage Door Installation
Sat May 11, 2024 4:21 am by shunchi320
» Garage Door Repair
Sat May 11, 2024 4:18 am by shunchi320
» Garage door still can open and close in a power outage
Sat May 11, 2024 4:16 am by shunchi320
» Tips For Installation Of Garage Door
Sat May 11, 2024 4:11 am by shunchi320