I am a sparky by trade but I have an issue with my dads garage door.
Ok so it opens a to about quarter of the way up then stops. If u press open again it goes up a few turns and then comes back down to the position it stopped at the first time. If u wind it up manually it comes down on the motor fine.
There is no beam but there is a pressure strip on the bottom. There are also a grey long panel that is screwed to the door with 3round batteries in which I have replaced and a grey square on the frame that lines up with this. I'm not to sure what this bit is? Could it be to link it to the alarm system maybe??
I can only think to replace the control panel but I'm not 100% this will solve the issue and I don't want to spend money if it's not required. It's an older door sws I think it has a light on the panel which flashes green Amber and red. The sequence of colours is a trouble shooter in the manual but if otter says different things ie different sequence of lights flashing?
Any help and advice would be great!!
Yesterday at 9:25 am by Altrio
» Is Impotence a Sign of an Underlying Health Condition?
Yesterday at 3:12 am by ameliajames
» Old Genie BlueMax resistance adjustment sensor
Mon Apr 29, 2024 9:19 pm by Bob52
» QR code menu
Mon Apr 29, 2024 1:34 pm by lefeni
» KDE's great video edito
Mon Apr 29, 2024 1:32 pm by lefeni
» Where is the microphone in iPhone 11?
Mon Apr 29, 2024 1:29 pm by lefeni
» How to Open Garage Door Manually from Inside and Outside
Mon Apr 29, 2024 5:45 am by melanie
» Install Overhead Door Company garage door
Fri Apr 26, 2024 10:45 am by dct@cox.net
» Craftsman Opener having issues
Fri Apr 26, 2024 7:30 am by Koby_BEZ