Garage Door Zone

Would you like to react to this message? Create an account in a few clicks or log in to continue.
Garage Door Zone

Questions & discussions of garage door operator problems and solutions.

Latest topics

» Garage door opens then door goes back a few inches then opens again...
Chamberlain chain tension EmptyToday at 4:29 am by shunchi320

» Door closing with loud noise, any suggestions
Chamberlain chain tension EmptyToday at 4:28 am by shunchi320

» Garage door not opening
Chamberlain chain tension EmptyToday at 4:26 am by shunchi320

» Commercial Garage Door Installation
Chamberlain chain tension EmptyToday at 4:21 am by shunchi320

» Garage Door Repair
Chamberlain chain tension EmptyToday at 4:18 am by shunchi320

» Garage door still can open and close in a power outage
Chamberlain chain tension EmptyToday at 4:16 am by shunchi320

» Tips For Installation Of Garage Door
Chamberlain chain tension EmptyToday at 4:11 am by shunchi320

» How much does the installation of a commercial or industrial garage door cost?
Chamberlain chain tension EmptyToday at 4:04 am by shunchi320

» Door wont close with remote
Chamberlain chain tension EmptyToday at 3:45 am by shunchi320

Keywords

raynor  liftmaster  problems  Chamberlain  linear  doors  open  button  wont  shaft  marantec  garage  wall  spring  opener  light  remote  sensor  Genie  close  Overhead  sensors  Seal  extension  model  craftsman  

Counter


    Chamberlain chain tension

    jcook2070
    avatar
    jcook2070


    Posts : 1
    Join date : 2020-04-08
    • Post n°1

    Chamberlain chain tension Empty Chamberlain chain tension

    Post  jcook2070 Wed Apr 08, 2020 1:18 pm

    Just replaced the motor and adjusted the chain tension but something seems off. The side of the chain that has the bolt adjustment isn’t too tight and I can easily move it with my finger. On the other side of the T-rail the tension on the chain is really tight. Loosening up the bolt side doesn’t really change the tension on the opposite side. I really don’t want to break the sprocket because one side is too tight. Any thoughts? Thanks
    • Back to top
      Current date/time is Sat May 11, 2024 4:41 am