raynor pilot - two garage doors in building ate the gears - installed a new set of gears, door went down perfectly, started up and stopped approx. 6" up. if i got it up, it would then only come down approx. 6" and stop. local installer said to try an rpm board. installed an rpm/interupter, door now closes, then starts to open approx. 6" and stops. if i get it up, it will then go down approx. 6" and stop. unlatch the door and it makes a normal run. is it now completley in the adjustment of pressure switches and top bottom limits?
Garage Door Zone
Questions & discussions of garage door operator problems and solutions.
2 posters
raynor pilot adjustment
GDZone- Admin
- Posts : 340
Join date : 2009-04-28
You could try adjusting the sensitivity. If that doesn't work then I would try replacing the limit assembly.
web- Posts : 2
Join date : 2011-02-01
thanks for the reply. i already got it and your right, it was the sensitivity. thanks
|
|
|
» Craftsman Opener having issues
» Sell My House Fast Phoenix
» MOTTIFY EU
» Where is best place to buy torsion shafts locally?
» Sears Door Sensors Won't Align
» Garage door spring repair
» Where is the microphone in iPhone 11?
» How to Side Swipe On Instagram?