Garage Door Zone

Would you like to react to this message? Create an account in a few clicks or log in to continue.
Garage Door Zone

Questions & discussions of garage door operator problems and solutions.

Latest topics

» Navigating the Academic Terrain: Evaluating Writing Service Reviews
Cables keep getting slack halfway up and flying off EmptyYesterday at 7:49 am by Edna Fosse

» Exploring Reviews of Legal and Trusted Online Casinos with OnlineCasinosSouthAfrica
Cables keep getting slack halfway up and flying off EmptyYesterday at 6:42 am by Willie Chapman

» Garage door opens then door goes back a few inches then opens again...
Cables keep getting slack halfway up and flying off EmptyYesterday at 4:29 am by shunchi320

» Door closing with loud noise, any suggestions
Cables keep getting slack halfway up and flying off EmptyYesterday at 4:28 am by shunchi320

» Garage door not opening
Cables keep getting slack halfway up and flying off EmptyYesterday at 4:26 am by shunchi320

» Commercial Garage Door Installation
Cables keep getting slack halfway up and flying off EmptyYesterday at 4:21 am by shunchi320

» Garage Door Repair
Cables keep getting slack halfway up and flying off EmptyYesterday at 4:18 am by shunchi320

» Garage door still can open and close in a power outage
Cables keep getting slack halfway up and flying off EmptyYesterday at 4:16 am by shunchi320

» Tips For Installation Of Garage Door
Cables keep getting slack halfway up and flying off EmptyYesterday at 4:11 am by shunchi320

Keywords

wont  Seal  sensor  linear  Chamberlain  sensors  model  light  Overhead  close  wall  Genie  open  shaft  raynor  doors  remote  craftsman  garage  marantec  opener  liftmaster  spring  problems  extension  button  

Counter


    Cables keep getting slack halfway up and flying off

    tloftis
    avatar
    tloftis


    Posts : 1
    Join date : 2020-05-01
    • Post n°1

    Cables keep getting slack halfway up and flying off Empty Cables keep getting slack halfway up and flying off

    Post  tloftis Fri May 01, 2020 8:08 pm

    I have watched everyvideo on youtube there is lol.  wound and rewould the spring, set the cable tension, everything I can think of.  the cables keep coming off.  it is something I am doing wrong of course.  I bought a new spring and this is happening now. the old left side YELLOW SPRING BROKE AND I bought a new left broke and I bought a new left red srpring. The only thing I can think of is I am winding it in the wrong direction. ????? When I put tension on it, the winding tool it loaded up and pressing up against the garage door and NOT the ceiling... is this correct?
    • Back to top
      Current date/time is Sun May 12, 2024 10:59 am